New View > Thumbnails view + details ( path)

[siomosp]

Hello!
It is possible to display thumbnails view with (some) details
I have the same file is 2 different paths and i want to see bellow of each file/thumbnail , the path
Regards
Panagiotis

[horst.epp]

The file name is shown below the picture.
If you hover it with he mouse you also see the path and other details.

[siomosp]

Hi,
thank you for the reply
I am asking for the path bellow each thumbnail (without the need of cliking each one)

[void]

Thank you for the feedback siomosp,

Everything currently only shows one line for the filename.

Showing up to 3 lines for the filename is on my TODO list.

I will consider an option to show the path under the thumbnail.

Thank you for your suggestion.



There is an option to show the full path and filename (instead of just the basename):

• In Everything, type in the following search and press ENTER:
  /display_full_path_name=1
  ---where 1 = show the full path and filename and 0 = show only the basename (default).
• If successful, you should see display_full_path_name=1 in the status bar for a few seconds.
• Unfortunately, with Everything currently only showing one line, it might make the filename difficult to read.

[horst.epp]

Hi,
thank you for the reply
I am asking for the path bellow each thumbnail (without the need of cliking each one)

You don't have to click, just hover with the mouse over the picture and it shows you the extended info.

[siomosp]

Thank you for the feedback siomosp,

Everything currently only shows one line for the filename.

Showing up to 3 lines for the filename is on my TODO list.

I will consider an option to show the path under the thumbnail.

Thank you for your suggestion.



There is an option to show the full path and filename (instead of just the basename):

• In Everything, type in the following search and press ENTER:
  /display_full_path_name=1
  ---where 1 = show the full path and filename and 0 = show only the basename (default).
• If successful, you should see display_full_path_name=1 in the status bar for a few seconds.
• Unfortunately, with Everything currently only showing one line, it might make the filename difficult to read.

Thank you!
Regards!